Custom-designed staples for rabbit jumping obstacles
These staples are uniquely developed by me and factory-produced according to my design – specially adapted for rabbit jumping. Made from stainless steel. The staples keep the pole stable even in strong winds, while still allowing it to be knocked off easily from both directions.
Fits poles with a diameter of 16–20 mm.

Dimensions: 40x23 mm, bend 8 mm, diameter 3 mm.

Installation
Follow the steps below for best results:
  
Pre-drill with a 3 mm bit, making a hole about 1–2 cm deep.
  
Apply glue inside the hole or on both ends of the staple.
  
Gently wiggle the staple in with your fingers or tap it in carefully with a hammer.
  
If glue gets on the staple or the obstacle, simply wipe it off.